IDF Tel Aviv 2005 Coverage
By Gabriel Torres on November 3, 2005


Intel has very high-end research and development facilities Ė including development sites for several Intel CPUs Ė and chip factory in Israel, so we were pretty excited in traveling half the Globe just to attend the first IDF held in Tel Aviv. We expected to see more info on forthcoming Intel products and we hit bullís eye: we could learn a lot more about new Intel CPUs, especially the new Merom/Conroe/Woodcrest family, the new Monahans cell phone application CPU and a little bit about the forthcoming 45 nm technology, since all these technologies are being developed in Israel.

At this IDF we could see a Conroe CPU prototype Ė which is the codename of the desktop CPU using Pentium M architecture that will replace Pentium 4 Ė and also an OEM notebook from ASUS based on the forthcoming Yonah CPU, which is the dual-core Pentium M manufactured on the 65 nm process.

Conroe Intel CPU
click to enlarge
Figure 1: Conroe CPU prototype.

ASUS Yonah Notebook
click to enlarge
Figure 2: ASUS OEM notebook based on Yonah CPU.

We had the chance of sitting and talking to Ron Friedman, Intelís VP in charge of Intelís MMG (Mobility Microprocessor Group) team, based in Haifa and which develops all Pentium M-class CPUs (Banias, Dothan, Yonah, Meron and even the next-generation 45 nm Intel CPU) and also the microarchitecture that will be used on desktop and servers starting next year.

The first successful commercial product from the Haifa team was Pentium with MMX technology (codenamed P55C, remember that one?) back in 1996. The next CPU development from them was a project codenamed Timna, a highly integrated CPU for the low-end market, which was cancelled when the product was finished and ready to go into production, basically because Intel decided to use the expensive Rambus memory with it.

From the Timna experience, however, came the expertise in projecting CPUs with great performance/power ratio, so they decided to go ahead with the project of a relatively low power CPU that would, at the same time, provide a great performance at lower clock frequency compared to desktop CPUs, codenamed Banias. This was 1999 and they didnít have a clue what the market response would be, especially because at the time everybody was only trying to reach higher clock frequencies, without caring too much with consumption or heat dissipation. This CPU was released in 2003 as Pentium M and in fact it was so successful that Intel decided to use its microarchitecture on all next-generation CPUs, from mobile to server, which we are going to be talking more in the next page.

Friedman explained us that this decision had a lot to do with multi-core technology. For example, making a dual-core version of Pentium 4 ďPrescottĒ, which can easily go around 100 W, is a pain, because theoretically its dual-core version would dissipate around 200 W. Even if the CPU dissipated 60 W making it double core would be very hard.

With Yonah, the dual-core Pentium M CPU manufactured in the new 65 nm process, ready to be released on the beginning of 2006, the Haifa team is now working on the 45 nm manufacturing process. Why shrinking down to 45 nm? According to Friedman, there are three basic reasons:

The problem, however, is current leakage. Transistors have an inherent leakage problem. When transistors are turned off, they are not exactly turned off; they let a little bit of electrical current to flow. On old CPUs operating at high voltages this wasnít a problem, because the leaked current would be negligible. On modern CPUs, however, not only the leaked current can be misinterpreted as if the transistor is turned on when in fact it is turned off, but also the leaked current is consuming energy, thus increasing the CPU power dissipation. So leakage is one of the enemies of lowering the CPU power consumption and heat dissipation.

Intelís Next Generation Microarchitecture

On this IDF we could get more details on the next microarchitecture that will be used on all new Intel CPUs starting on the second half of 2006 and which was developed by the Haifa team. As we mentioned, this microarchitecture is based on Pentium Mís and not on Pentium 4ís. We have already posted a tutorial about Pentium 4 microarchitecture, so you may be interested in reading it for better understanding this subject and also for understanding the technical terms we are talking about below. This will be Intelís 8th x86 microarchitecture generation.

First, it will use a 14-stage pipeline, opposed to Pentium 4ís 21-stage pipeline and to Prescottís 30-stage pipeline. So in this respect this new microarchitecture is more like Intelís 6th generation CPUs, like Pentium III, than Intelís 7th generation CPUs.

It will have four dispatch units against the three used on Pentium 4. Simply put, it will be able to send more microinstructions per time to the CPU execution units, which obviously increases performance.

On the cache side, it will use a shared L2 cache for all the CPU cores, just like Yonah, the dual-core Pentium M CPU manufactured in the new 65-nm process that will be released in the beginning of next year. This was made in order to decrease the cache-miss rate, i.e., decrease the number of times that the CPU run out of cache and needs to go to the slow RAM memory to grab data. With a shared L2 cache between all CPU cores, the CPU can dynamically give more or less L2 cache for each core depending on the demand. In a dual-core CPU with separated L2 caches, if one core runs out of cache, it must go and get data directly on the RAM memory, even if the L2 cache from the other core has plenty of space available. On the shared model, if the CPU has 2 MB total L2 cache, for example, one core may be using 1.5 MB and the other 0.5 MB of it, thus decreasing the number of times the CPU needs to grab data directly on RAM memory, increasing performance.

Intel is also promising that the L1 memory caches from each core will be able to directly communicate to each other and also a higher bandwidth between the CPU core and the L2 memory cache.

Another thing new on this architecture will be a new multimedia instruction set (SSE4?), the fifth multimedia instruction set since MMX was released back in 1996.

All CPUs will incorporate the 64-bit addressing extension, EM64T.

The difference between Merom, for mobile market, Conroe, for desktops, and Woodcrest, for servers, will be basically the L2 memory cache size, the TLB (Translation Look-aside Buffer) size and the amount of RAM memory the CPU can address. TLB is a table used by the virtual memory system (a.k.a. swap file) that lists the physical address page number associated with each virtual address page number.

Monahans Cell Phone Application CPU

During this IDF Intel showed their next generation cell phone application CPU, codenamed Monahans. The prototype shown was running at an impressive 1,248 MHz clock rate. It is really amazing to think that a cell phone will be using a CPU clocked higher than desktop CPUs not so long ago.

Monahans Cell CPU
click to enlarge
Figure 3: Monahans cell phone CPU running at 1,248 MHz.

Monahans Cell CPU
click to enlarge
Figure 4: Monahans development board.

So, who needs a cell phone with a CPU running over 1 GHz? The only application that demands such performance level is video. So this is an application CPU targeted to high-end cell phones with big color displays, being able to play videos at 30 FPS (Frames Per Second) instead of 15 FPS, which the current rate for todayís high-end cell phones.

IAMT Demo

Intel demonstrated their Active Management Technology, IAMT. With this technology it is possible for system administrators to perform the maintenance of the computers remotely, including turning them on, running anything needed, and then turning them off. This maintenance can be even entering the BIOS setup, as it was demonstrated.

So, with this technology administrators can save a lot of time because they donít need to physically go to where the faulty computer is located.

Also, with Intelís virtualization technology, which allows the same computer to be divided into several different partitions as if it were several computers, this remote maintenance can be done even with the computer being used by the user while he is doing something else.

Intel Active Management Technology
click to enlarge
Figure 5: Video monitor of the computer being remotely controlled.

Intel Active Management Technology
click to enlarge
Figure 6: Video monitor of the system administrator computer, as you can see it is controlling the BIOS setup of the computer in Figure 5.

Originally at http://www.hardwaresecrets.com/article/IDF-Tel-Aviv-2005-Coverage/242


© 2004-13, Hardware Secrets, LLC. All Rights Reserved.

Total or partial reproduction of the contents of this site, as well as that of the texts available for downloading, be this in the electronic media, in print, or any other form of distribution, is expressly forbidden. Those who do not comply with these copyright laws will be indicted and punished according to the International Copyrights Law.

We do not take responsibility for material damage of any kind caused by the use of information contained in Hardware Secrets.