Western Digital VelociRaptor WD3000GLFS Hard Disk Drive Review
By Gabriel Torres on June 19, 2008 Page 2 of 5

How We Tested

During our tests we used the configuration listed below and the only variable component between each benchmarking session was the hard disk drive being tested. We also build a RAID0 array with two Seagate Barracuda 7200.10 160 GB (ST3160815AS, SATA-300, 7,200 rpm, 8 MB buffer) hard disk drives with the ICH9R south bridge chip from the motherboard we were using (ASUS P5K-E/WiFi-AP, which is based on Intel P35 chipset), using the recommended strip size, 128 KB.

Hardware Configuration

Software Configuration

  • Windows XP Professional using NTFS file system
  • Service Pack 3
  • Intel Inf driver version: 8.3.1.1009
  • nVidia video driver version: 169.21

Benchmarking Software

We adopted a 3% error margin. So, performance differences below 3% cannot be considered meaningful. In other words, products where the performance difference is below 3% must be considered as having similar performance.


Originally at http://www.hardwaresecrets.com/article/567/2Pages (5): 1 2 3 4 5 »

© 2004-9, Hardware Secrets, LLC. All Rights Reserved.

Total or partial reproduction of the contents of this site, as well as that of the texts available for downloading, be this in the electronic media, in print, or any other form of distribution, is expressly forbidden. Those who do not comply with these copyright laws will be indicted and punished according to the International Copyrights Law.

We do not take responsibility for material damage of any kind caused by the use of information contained in Hardware Secrets.