Secondary Analysis

This power supply has six Schottky rectifiers on its secondary, two for each positive voltage output (+12 V, +5 V and +3.3 V). Zalman ZM360B-APS uses only four rectifiers and we can’t tell about Zalman ZM460B-APS yet, even though we suspect Zalman ZM460B-APS and SilverStone Strider ST50F are identical.

The +12 V output is produced by two MBR2560CT Schottky rectifiers connected in parallel. Since each one supports up to 30 A at 130º C we have a maximum theoretical current for the +12 V output of 60 A or 720 W. Of course the maximum current (and thus power) this line can really deliver will depend on other components, especially the transformer, the coil, the capacitor and the wire gauge used.

The +5 V output is produced by two MBR3045N Schottky rectifiers, supporting up to 30 A at 100º C each. So the maximum theoretical current the +5 V output can deliver is of 60 A or 300 W. Of course the maximum current (and thus power) this line can really deliver will depend on other components, especially the transformer, the coil, the capacitor and the wire gauge used, as we mentioned before.

The +3.3 V output is produced by other two MBRP3045N Schottky rectifiers, supporting up to 30 A at 100º C each. So the maximum theoretical current the +3.3 V output can deliver is of 60 A or 198 W. As mentioned the real power this line can deliver depends on other factors.

click to enlarge
Figure 15: +12 V, +5 V and +3.3 V rectifiers.

This power supply uses a PS223 monitoring integrated circuit, which is in charge of the power supply protections, like OCP (over current protection). OCP was really activated, as we will talk about later. This IC also provides over voltage protection (OVP), under voltage protection (UVP) and over temperature protection (OTP), but not over power protection (OPP).

click to enlarge
Figure 16: PS223 monitoring integrated circuit.

The thermal sensor is located under the secondary heatsink, as you can see on Figure 17 (we took this picture with the heatsink removed). This sensor is used to control the fan speed according to the power supply internal temperature and to shut down the power supply in an overheating situation. As we mentioned, the monitoring IC supports this protection and SilverStone says this unit features this protection. We, however, couldn’t test this feature, as the power supply was always working very cool.

click to enlarge
Figure 17: Thermal sensor.

On this power supply all electrolytic capacitors are Taiwanese from CapXon, with the active PFC capacitor rated at 85º C and the secondary capacitors rated at 105º C.

Total or partial reproduction of the contents of this site, as well as that of the texts available for downloading, be this in the electronic media, in print, or any other form of distribution, is expressly forbidden. Those who do not comply with these copyright laws will be indicted and punished according to the International Copyrights Law.

We do not take responsibility for material damage of any kind caused by the use of information contained in Hardware Secrets.