SilverStone Strider ST50F 500 W Power Supply Review
By Gabriel Torres on April 26, 2008 Page 4 of 10

Primary Analysis

Hardware Secrets Silver AwardWe were very curious to check what components were chosen for the power section of this power supply, especially because it uses the same project as Zalman ZM360B-APS and ZM460B-APS.

This power supply uses one GBU806 rectifying bridge on its primary stage, which can deliver up to 8 A (rated at 100º C). This bridge is attached to the same heatsink where the switching transistors are located. Zalman ZM360B-APS uses a GBU606 bridge, which can deliver less current (6 A). We can’t tell about ZM460B-APS as we haven’t reviewed this unit yet.

SilverStone Strider ST50F 500 W Power Supply
click to enlarge
Figure 11: Rectifying bridge.

On the active PFC circuit two 20N60C3 power MOSFET transistors are used, each one capable of handling up to 20.7 A at 25º C or 13.1 at 100º C in continuous mode or up to 62.1 A at 25º C in pulse mode. These transistors are located on a separated heatsink, together with the active PFC diode. Zalman ZM360B-APS uses two STP14NK50ZFP, which are capable of handling less current (14 A at 25º C or 7.6 at 100º C in continuous mode or up to 48 A at 25º C in pulse mode). Once again we can’t tell about ZM460B-APS as we haven’t reviewed this unit yet.

SilverStone Strider ST50F 500 W Power Supply
click to enlarge
Figure 12: Active PFC transistors and diode.

On the switching section this power supply uses two STF21NM50N power MOSFET transistors in two-transistor forward configuration. Each one of these transistors can deliver up to 18 A at 25º C or 11A at 100º C or up to 72 A at 25º C in pulse mode, which is the mode used. Here again the components were upgraded, as Zalman ZM360B-APS uses two FQPF9N50C, which can deliver less current (9 A at 25º C or 5.4 A at 100º C in continuous mode or up to 36 A at 25º C in pulse mode). Once again we can’t tell about ZM460B-APS as we haven’t reviewed this unit yet. As mentioned, these transistors are located on the same heatsink as the rectifying bridge.

SilverStone Strider ST50F 500 W Power Supply
click to enlarge
Figure 13: Switching transistors.

The primary section is controlled by a CM6800 integrated circuit, which is a very popular active PFC and PWM controller combo. It is located on a small printed circuit board attached to the main board.

SilverStone Strider ST50F 500 W Power Supply
click to enlarge
Figure 14: PFC and PWM controller combo.


Originally at http://www.hardwaresecrets.com/article/548/4Pages (10): 1 2 3 4 5 6 7 8 » ... Last »

© 2004-8, Hardware Secrets, LLC. All Rights Reserved.

Total or partial reproduction of the contents of this site, as well as that of the texts available for downloading, be this in the electronic media, in print, or any other form of distribution, is expressly forbidden. Those who do not comply with these copyright laws will be indicted and punished according to the International Copyrights Law.

We do not take responsibility for material damage of any kind caused by the use of information contained in Hardware Secrets.