Introduction

Theorically ATA-33 hard disks have a 33 MB/s transfer rate, ATA-66 hard disks have a 66 MB/s transfer rate and so on. But achieving maximum performance with hard disks from ATA-33 on is not a matter of just plugging in the new hard disk on your computer. A lot of times, you won't achieve not even close to the hard disk's maximum transfer rate. In this tutorial we will explain why this happens and how to correctly set up your computer to reach the maximum transfer rate you hard disk is able to provide.

You can check the current transfer rate from your hard disk by using the software HD Tach, available at our download section. Our Figure 1 was taken in a computer with an ATA-66 hard disk. As you can see, the transfer rate achieved was only 8.2 MB/s, and the CPU utilization was over 90%.

click to enlarge
Figure 1: 8.2 MB/s transfer rate and 92.7% CPU utilization with an ATA-66 hard disk. Something got to be wrong!

This tutorial is about why this problem happens and how to fix it. After reading this tutorial and applying the suggested corrections to your computer, you should achieve something like shown on Figure 2, where the same hard disk, on the same computer, achieved 46 MB/s and 2.7% CPU utilization.

click to enlarge
Figure 2: After correct computer configuration, 46 MB/s transfer rate and 2.7% CPU utilization.

You have to keep in mind that the listed transfer rate (66 MB/s, 100 MB/s, 133 MB/s etc) is rarelly achieved, as you can see on Figure 2 where an ATA-66 hard disk achieved 46 MB/s. But far better than 8 MB/s!

Total or partial reproduction of the contents of this site, as well as that of the texts available for downloading, be this in the electronic media, in print, or any other form of distribution, is expressly forbidden. Those who do not comply with these copyright laws will be indicted and punished according to the International Copyrights Law.

We do not take responsibility for material damage of any kind caused by the use of information contained in Hardware Secrets.