Inside Mercury Pro

On Figure 8 you can see Mercury Pro rear panel. As you can see, it comes with two 120 mm fans on its rear (which glow blue when turned on) and it has seven expansion slots. You can also see that there are two holes for hoses, so you will be able to add external water cooling devices. If you want to install a power supply that is longer than normal (e.g. Enermax Galaxy 1,000 W) part of the unit will be left outside the case, and this case comes with a frame to correctly fasten this type of power supply to the case.

click to enlarge
Figure 8: Mercury Pro rear panel.

On Figure 9 you can see inside the rear panel from inside Mercury Pro. You can see the two 120 mm fans, the water splitters and the CPU block.

click to enlarge
Figure 9: Mercury Pro rear panel, view from inside.

On Figure 10 you can see inside Mercury Pro.

click to enlarge
Figure 10: Inside Mercury Pro.

As you already know, this case has four 5 ¼” bays, two 3 ½” bays and five internal 3 ½” bays. As you can see on Figure 10, these internal bays are 90º rotate compared to traditional cases, making it easier to install hard disk drives on this product.

On Mercury Pro there is a tool box installed on two of the internal bays (see Figure 11), so if you want to use more than three bays you will need to remove this box.

click to enlarge
Figure 11: Tool box.

Total or partial reproduction of the contents of this site, as well as that of the texts available for downloading, be this in the electronic media, in print, or any other form of distribution, is expressly forbidden. Those who do not comply with these copyright laws will be indicted and punished according to the International Copyrights Law.

We do not take responsibility for material damage of any kind caused by the use of information contained in Hardware Secrets.