| How to Setup a RAID System | |
| By Gabriel Torres on October 24, 2006 | Page 3 of 8 |
Physical Installation The RAID installation process is divided into three parts:
It is very important to notice that setting up a RAID system deletes all data inside your hard disk drives. So make a backup of all your data before continuing, if your hard disk drives have important data inside. The physical installation is pretty straightforward: install your hard disk drives to your case, connect a power supply plug on each hard disk drive and connect each hard disk drive to the appropriate hard disk drive port on the motherboard (if your motherboard doesn’t support RAID you will need to buy a RAID controller card and install your hard disk drives to it). Of course this procedure must be done with your computer turned off. On the pictures below we removed the system from the case for clearer pictures. On this tutorial we are using an Intel D975XBX2 motherboard and two Samsung HD080HJ hard disk drives (80 GB, SATA-300). It is important to use ports that can deliver the maximum performance your hard disk drive is able to reach. There are two main hard disk interface standards, parallel ATA (PATA or simply IDE) and Serial ATA (SATA). PATA ports are fading away, with SATA ports being the standard today. If you are assembling a new system, do not use parallel ATA hard disk drives. Parallel ATA can be found in two speeds, ATA/100 and ATA/133. Of course the best scenario if you are still using this kind of hard disk drive is to use ATA/133 drives together with ATA/133 ports. For the best performance you need to install each hard disk drive on a separated port, each one configured as “master” and using its own 80-wire cable. Do not install them on the same cable using master/slave configuration as this reduces performance. Unfortunately newer motherboards usually don’t have more than one parallel ATA port, making it a very bad choice to use parallel ATA hard disk drives. Don’t forget that the parallel ATA ports must support RAID, of course. The parallel ATA ports shown on Figure 4 are not the ones controlled by the chipset, but two extra IDE ports provided by an extra chip, supporting RAID.
Since parallel ATA is fading away, we are going to focus on Serial ATA. Serial ATA can also be found in two speeds, SATA-150 (a.k.a. 1.5 Gbps) and SATA-300 (a.k.a. 3 Gbps). The best performance can be achieved with SATA-300 ports and SATA-300 hard disk drives. The installation is pretty easy. Connect one SATA cable to each hard disk drive and connect one SATA power cable to each hard disk drive (if your power supply doesn’t have SATA power cables, SATA hard disk drives come with an adaptor that converts the standard peripheral power plug into a SATA power plug).
Then install the other end of each cable to an available SATA port on your motherboard. For better organization, use the lowest numbered ports. For example, on our motherboard the four ports controlled by the ICH6R south bridge were labeled SATA0, SATA1, SATA2 and SATA3. We used SATA0 and SATA1 ports. Remember that you must install the cables to ports that support RAID (see previous page for a detailed discussion on this subject).
Now you will need to set up the hard disk drives as a RAID array. Let’s show how this can be done on next page. | |
| Originally at http://www.hardwaresecrets.com/article/393/3 | Pages (8): 1 2 3 4 5 6 7 8 » |
© 2004-8, Hardware Secrets, LLC. All Rights Reserved. Total or partial reproduction of the contents of this site, as well as that of the texts available for downloading, be this in the electronic media, in print, or any other form of distribution, is expressly forbidden. Those who do not comply with these copyright laws will be indicted and punished according to the International Copyrights Law. We do not take responsibility for material damage of any kind caused by the use of information contained in Hardware Secrets. | |