Switching Transistors

The switching section of switching mode power supplies can be built using several different configurations. We summarized the most common ones on the table below.

Of course we are just analyzing the number of components needed, there are other aspects that engineers should take into account when deciding which configuration to use.

The two most common configurations for PC power supplies are the two-transistor forward and the push-pull, and both use two switching transistors. The physical aspect of these transistors – which are power MOSFET transistors – can be seen on the previous page. They are attached to the heatsink found on the power supply primary section.

Below we show you the schematics for each one of these five configurations.

click to enlarge
Figure 19: Single-transistor forward configuration.

click to enlarge
Figure 20: Two-transistor forward configuration.

click to enlarge
Figure 21: Half bridge configuration.

click to enlarge
Figure 22: Full bridge configuration.

click to enlarge
Figure 23: Push-pull configuration.

Total or partial reproduction of the contents of this site, as well as that of the texts available for downloading, be this in the electronic media, in print, or any other form of distribution, is expressly forbidden. Those who do not comply with these copyright laws will be indicted and punished according to the International Copyrights Law.

We do not take responsibility for material damage of any kind caused by the use of information contained in Hardware Secrets.