Voltage Doubler and Primary Rectifier

On power supplies without active PCF circuit you will find a voltage doubler. The voltage doubler uses two big electrolytic capacitors. So the bigger capacitors found on the power supply belongs to this stage. Like we mentioned before, the voltage doubler is only used if you are connecting your power supply to a 127 V power grid.

click to enlarge
Figure 13: Electrolytic capacitors from the voltage doubler.

click to enlarge
Figure 14: Electrolytic capacitors from the voltage doubler removed from the power supply.

Next to the two electrolytic capacitors you will find a rectifying bridge. This bridge can be made by four diodes or by a single component, see Figure 15. On high-performance power supplies this rectifying bridge is connected to a heatsink.

click to enlarge
Figure 15: Rectifying bridge.

On the primary you will also find a NTC thermistor, which is a resistor that changes its resistance according to the temperature. It is used to reconfigure the power supply after it is used for a while and it is hot. NTC stands for Negative Temperature Coefficient. This component resembles a ceramic disc capacitor and is usually olive green.

Total or partial reproduction of the contents of this site, as well as that of the texts available for downloading, be this in the electronic media, in print, or any other form of distribution, is expressly forbidden. Those who do not comply with these copyright laws will be indicted and punished according to the International Copyrights Law.

We do not take responsibility for material damage of any kind caused by the use of information contained in Hardware Secrets.