Installing Video Capture Boards (Cont’d)

Some video capture cards have a small squared internal audio output, to be connected to your motherboard (or to your sound card, if you use and add-in sound card instead of your motherboard’s on-board audio). This connection allows you to listed to what is being captured thru the PC speakers. Without this connection you will be able to listen to what you have captured only after playing the generated file. For this connection you will need a cable that comes with the video capture board.

click to enlarge
Figure 7: Cable for connecting the internal audio output.

click to enlarge
Figure 8: Cable installed on the video capture card.

Install one end of the cable on the appropriate connector on your video capture card (see Figure 8) and the other end on your motherboard, on a connector labeled “Aux In”. Look for this connector carefully, as it may be difficult to locate it, since it is usually located near or under the video card.

click to enlarge
Figure 9: Aux In connector.

click to enlarge
Figure 10: Installing the internal audio cable.

click to enlarge
Figure 11: Internal audio cable installed.

Some motherboards don’t have an Aux In input. In this case you have two options. Don’t make this connection – what will prevent you to hear what is being captured in real-time – or connect the cable to the CD In connector – but in this case you will lose the audio connection of your DVD burner, which may be even worse.

Total or partial reproduction of the contents of this site, as well as that of the texts available for downloading, be this in the electronic media, in print, or any other form of distribution, is expressly forbidden. Those who do not comply with these copyright laws will be indicted and punished according to the International Copyrights Law.

We do not take responsibility for material damage of any kind caused by the use of information contained in Hardware Secrets.