How To Correctly Apply Thermal Grease
By Gabriel Torres and Daniel Barros and Cássio Lima on January 12, 2006 Page 12 of 12

Most Common Mistakes

Every day in our labs we see many different mistakes regarding cooler installation and use of thermal grease.

The most common is using too much thermal grease. Excess of thermal grease spoils the correct heat dissipation, besides the possibility of drop to the outside and putting the system in danger.

Processors that have exposed components, such as the Athlon XP, can be subject to short circuits if the thermal grease closes the contact of its bridges or of the exposed components, such as capacitors and resistors.

In the processor in Figure 42, besides the excess of thermal grease, someone stuck a warranty seal right on top of the processor rubber pads that support the cooler. The thickness of that seal increases the pressure on top of the processor, and this pressure can break it.

Thermal Grease
click to enlarge
Figure 42: Duron with too much thermal grease and seal covering the rubber pads.

Another very common mistake are the warranty seals placed on the contact part between the heatsink and the processor. Don’t accept processors with seals covering it. If you have a processor with a seal on its top, remove it right away.

The processor in Figure 43 is a poor 200 MHz Pentium MMX. Besides the seal covering practically the whole contact area between the processor and the heatsink, it was also using the cooler in Figure 7, that uses graphite as heat conductor.

Thermal Grease
click to enlarge
Figure 43: Seal covering practically all the processor.

Other problems that we frequently see are broken processors – mainly Athlon XP and Sempron socket 462 processors – due to mistakes during cooler installation (putting the cooler at the wrong position or using too much strength when fixing the cooler) and people that substitute the thermal grease to toothpaste, liquid silicone, olive oil, glue, etc. Believe us, it happens!

Thermal Grease
click to enlarge
Figure 44: Socket 462 cooler installed in the wrong position.

Thermal Grease
click to enlarge
Figure 45: Processor damaged due to bad cooler mounting.


Originally at http://www.hardwaresecrets.com/article/274/12Pages (12): 1 2 3 4 5 6 7 8 » ... Last »

© 2004-8, Hardware Secrets, LLC. All Rights Reserved.

Total or partial reproduction of the contents of this site, as well as that of the texts available for downloading, be this in the electronic media, in print, or any other form of distribution, is expressly forbidden. Those who do not comply with these copyright laws will be indicted and punished according to the International Copyrights Law.

We do not take responsibility for material damage of any kind caused by the use of information contained in Hardware Secrets.