Operation Modes

The PCI Express bus has been developed to substitute PCI and AGP buses. It’s compatible in terms of software to the PCI bus, which means old drivers and operating systems don’t need to go through changes in order to support the PCI Express bus.

The PCI Express bus is a serial bus that works in full-duplex mode. Data is transmitted in this bus through two pairs of wires called lane, by using the codification system 8b/10b, the same system used in Fast Ethernet (100BaseT, 100 Mbps) networks. Each lane allows a maximum transfer rate of 250 MB/s in each direction, almost twice the rate of the PCI bus. The PCI Express bus can be built by combining several lanes in order to achieve higher performance. We can find PCI Express systems with 1, 2, 4, 8, 16 and 32 lanes. For example, the transfer rate of a PCI Express system with 8 lanes (x8) is 2 GB/s (250 * 8). 

click to enlarge
Figure 3: PCI Express x2 bus.

On the chart below we compared the transfer rates of the PCI, AGP and PCI Express busses.

The PCI Express bus is hot plug, i.e., it’s possible to install and remove PCI Express boards even when the PC is on.

Total or partial reproduction of the contents of this site, as well as that of the texts available for downloading, be this in the electronic media, in print, or any other form of distribution, is expressly forbidden. Those who do not comply with these copyright laws will be indicted and punished according to the International Copyrights Law.

We do not take responsibility for material damage of any kind caused by the use of information contained in Hardware Secrets.