Introduction

During IDF (Intel Developer Forum) Fall 2005, which is happening right now in San Francisco, California, Intel presented the final specs for the new CE-ATA hard drive standard, especially the connector format this new standard will use. The images you will see in this article are from CE-ATA presentation on this show.

CE-ATA is a standard for small hard drives targeted to consumer electronics products, such as media players (MP3, video, etc), digital cameras and digital camcorders. Right now the main standard available to this segment is CF+ (Compact Flash), which uses a 50-pin connector. Too many pins for a very small device – consumer electronics products use 1-inch hard drives! Also it uses 5 V signals, while everything else has already moved or is moving to 3.3 V signaling.

click to enlarge
Figure 1: An overall look on CF+ solution.

CE-ATA connector uses only 10 pins and has only 1/200th the volume of CF+:

• CF+ connector: 1.69 x 1.43 x 0.13 inches (42.8 x 36.4 x 3.3 mm)
• CE-ATA connector: 0.32 x 0.13 x 0.035 inches (8.1 x 3.4 x 0.9 mm)

click to enlarge
Figure 2: CE-ATA connector compared to CF+.

On Figure 3 you can see a CE-ATA drive from Hitachi, which measures only 1.18 x 1.58 inches (30 mm x 40 mm). Compare it to a quarter, it’s really amazing. Its connector has Washington’s nose to chin distance!

click to enlarge
Figure 3: CE-ATA hard drive.

Total or partial reproduction of the contents of this site, as well as that of the texts available for downloading, be this in the electronic media, in print, or any other form of distribution, is expressly forbidden. Those who do not comply with these copyright laws will be indicted and punished according to the International Copyrights Law.

We do not take responsibility for material damage of any kind caused by the use of information contained in Hardware Secrets.