Resistive Termination

On DDR modules the necessary resistive termination is located on the motherboard, while on DDR2 modules this termination is located inside the memory chips – technique called ODT, On-Die Termination.

This is done in order to make the signal “cleaner”. On Figure 4 you can see the signal that reaches the memory chip. On the left hand side you see the signals on a system that uses motherboard termination (DDR memories) while on the right hand side you see the signals on a system that uses on-die termination (DDR2 memories). Even a layman can easily say that the signals on the right hand side are cleaner and stable than the signals on the left hand side. On the yellow square you can compare the time frame difference – this time frame is the time the memory has to read or write a piece of data. With the use of on-die termination this time frame got wider, allowing higher clocks to be achieved since the memory has more time to read or write a data chunk.

click to enlarge
Figure 4: Comparison between motherboard termination and on-die termination.

Total or partial reproduction of the contents of this site, as well as that of the texts available for downloading, be this in the electronic media, in print, or any other form of distribution, is expressly forbidden. Those who do not comply with these copyright laws will be indicted and punished according to the International Copyrights Law.

We do not take responsibility for material damage of any kind caused by the use of information contained in Hardware Secrets.