SHARE

Installation

To install the ETD-T60-VD, first screw the metal clips to the base of the cooler, as shown in Figure 12.

Enermax ETD-T60-VDFigure 12: Clips

Then put the cooler over the CPU, place the backplate on the solder side of the motherboard, and secure it with four nuts, as shown in Figure 13.

Enermax ETD-T60-VDFigure 13: Backplate

Figure 14 shows the cooler installed, without the fan. Notice it doesn’t interfere with the memory sockets.

Enermax ETD-T60-VDFigure 14: Heatsink installed

In Figure 15, you can see the cooler with the fan turned on. There are several “special effects” that you can achieve with the fan LEDs.

Enermax ETD-T60-VDFigure 15: The CPU cooler turned on

1
2
3
4
5
6
7
8
Rafael Otto Coelho is a physicist with a master's degree in Education, and is a college professor in Brazil.