Cooler Master Vortex 752
This cooler uses a horizontal aluminum fin heatsink design, connected to the base by two copper heatpipes. The fins over the base are full-height, from the base to the top.
In a front view we can see the copper heatpipes in contact to the copper base, bringing heat to the top of the heatsink.
In Figure 6 we have a rear view of the Vortex 752, where we can see the heatpipes tips. We also noticed the fan is attached to the heatsink using four rubber holders. On next page we will have a closer look at this system.
- 1. Introduction
- 2. Cooler Master Vortex 752
- 3. Cooler Master Vortex 752 (cont’d)
- 4. Installation
- 5. How We Tested
- 6. Our Tests
- 7. Main Specifications
- 8. Conclusions