XFX is releasing their PRO series of power supplies, with single +12 V rail, DC-DC secondary design, and 80 Plus Bronze certification. So far three models were released: 650 W, 750 W, and 850 W. We have already tested the 650 W model, which proved to have a terrific cost/benefit ratio. Let’s see if the 750 W model follows the same path.

Like other power supplies from XFX, members of the Pro series are manufactured by Seasonic.

click to enlarge
Figure 1: XFX PRO 750 W power supply

click to enlarge
Figure 2: XFX PRO 750 W power supply

Like the PRO 650W, the PRO 750 W is 6.7” (170 mm) deep, with a 135 mm dual ball bearing fan (ADDA ADN512UB-A90) on its bottom part.

The new XFX PRO 750 W doesn’t have a modular cabling system. All cables are protected with nylon sleeves. The power supply comes with the following cables:

• Main motherboard cable with a 20/24-pin connector, 22.4” (57 cm) long
• One cable with two ATX12V connectors that together form an EPS12V connector, 24” (61 cm) long
• Two cables with one six-pin connector for video cards each, 22.8” (58 cm) long
• Two cables with one six/eight-pin connector for video cards each, 22.8” (58 cm) long
• Two cables with four SATA power connectors each, 15” (38 cm) to the first connector, 5.9” (15 cm) between connectors
• One cable with four standard peripheral power connectors, 15” (38 cm) to the first connector, 5.9” (15 cm) between connectors
• One cable with three standard peripheral power connectors and one floppy disk drive power connector, 15” (38 cm) to the first connector, 5.9” (15 cm) between connectors

All wires are 18 AWG, which is the minimum recommended gauge.

This is the same cable configuration found on the 650 W model, and is adequate for a 750 W unit.

click to enlarge
Figure 3: Cables

Let’s now take an in-depth look inside this power supply.