Installing the new module is relatively easy. Insert the new module in the open memory slot at a 45º angle, paying attention to match the notch located on the memory module with the notch located on the memory slot.
click to enlarge
Figure 12: Inserting the memory module in the memory slot
After inserting the memory module, you need to push it until it reaches the end of the slot, as we show in Figure 13.
click to enlarge
Figure 13: Push the module until the end of the memory slot
Then push the module down until you hear the click from the module locks, which means that the module is locked in the slot.
click to enlarge
Figure 14: Push the module down
After that your new module will be installed. Close your notebook following in reverse the way you used to open it. In our case, putting the keyboard back in place, pushing it forward, and screwing it back to the notebook.
click to enlarge
Figure 15: New module correctly installed
Turn your notebook on, and run Everest once again to check if the new module is being correctly recognized and if it is working well. As you can see in Figure 16, our new 1 GB module is being recognized correctly, and our computer now has 1,280 MB.
click to enlarge
Figure 16: Checking the new module after its installation
If your new memory module is not being recognized at all, you should remove it and install it again. You probably didn’t push it until it reached the end of the slot (Figure 13).
If your computer is not recognizing the full capacity of your new memory module (for example, a 1 GB module being recognized as 512 MB or less) this means that you installed a module with a capacity greater than your notebook is capable of handling.
