We are adopting the following methodology for our CPU cooler reviews.

First, we chose the CPU with the highest TDP (Thermal Design Power) we had available, a Core 2 Extreme QX6850, which has a 130 W TDP. The choice for a CPU with a high TDP is obvious. To measure the efficiency of the tested cooler, we need a processor that gets very hot. This CPU works by default at 3.0 GHz, but we overclocked it to 3.33 GHz, in order to heat it as much as possible.

We took noise and temperature measurements with the CPU idle and under full load. In order to achieve 100% CPU load on the four processing cores we ran Prime95 with the "In-place Large FFTs" option, and three instances of the StressCPU program, all at the same time.

We also compared the reviewed cooler to the Intel stock cooler (with copper base), which comes with the processor we used, and also with some other coolers we have tested using the same methodology.

Temperature measurements were taken with a digital thermometer, with the sensor touching the base of the cooler, and also with the core temperature reading (given by the CPU thermal sensor) from the from the SpeedFan program, using an arithmetic average of the four core temperature readings.

The sound pressure level (SPL) was measured with a digital noise meter, with its sensor placed 4" (10 cm) from the fan. We turned off the video board cooler so it wouldn't interfere with the results, but this measurement is only for comparative purposes, because a precise SPL measurement needs to be made inside an acoustically insulated room with no other noise sources, which is not the case here.

Hardware Configuration

• Processor: Core 2 Extreme QX6850
• Motherboard: Gigabyte EP45-UD3L
• Memory: 2 GB Corsair XMS2 DHX TWIN2X2048-6400C4DHX G (DDR2-800/PC2-6400 with timings 4-4-4-12), running at 800 MHz
• Hard drive: 500 GB Seagate Barracuda 7200.11 (ST3500320AS, SATA-300, 7200 rpm, 32 MB buffer)
• Video card: PNY Verto Geforce 9600 GT
• Video resolution: 1680x1050
• Video monitor: Samsung Syncmaster 2232BW Plus
• Power supply required: Seventeam ST-550P-AM
• Case: 3RSystem K100
  

Software Configuration

• Windows XP Professional installed on FAT32 partition
• Service Pack 3
• Intel Inf driver version: 8.3.1.1009
• NVIDIA video driver version: 182.08

Software Used

• Prime95
• StressCPU
• SpeedFan

Error Margin

We adopted a 2 ^oC error margin, i.e., temperature differences below 2 ^oC are considered irrelevant.