As we have seen in the previous figures, Buffalo's holding system is identhical to the one used on Intel stock coolers. So, you just need to put the cooler in place and press the four clips until you hear the characteristic click.

In Figure 10 we can see how Buffalo looks after it is installed on our motherboard. As it is not very big, it did not interfere with any motherboard component, nor with tall memory modules.

click to enlarge
Figure 10: Installed on motherboard.

In Figure 11, you can see the cooler installed into our case. It is not a big cooler, but it is not low, and will not fit slim or SFF cases.

click to enlarge
Figure 11: Installed on case.