As we mentioned on other articles and reviews, the first place we like to take a look when opening a power supply to have a hint about its quality is its filtering stage. The recommend components for this stage are two ferrite coils, two ceramic capacitors (Y capacitors, usually blue), one metalized polyester capacitor (X capacitor) and one MOV (Metal-Oxide Varistor). Very low-end power supplies use fewer components than that, usually removing the MOV and the first coil.

This power supply brings all the recommended components plus one extra X capacitor (and another extra X capacitor after the rectifying bridge) and two extra Y capacitors (behind the X capacitor on Figure 6). The MOV is located after the rectification bridge, and not before as usual (not shown on the pictures below, but you can see it on Figure 9 on next page). And the fuse is located on the first part of the transient filtering stage, i.e. on a small printed circuit board attached to the main AC power plug. This power supply uses a fuse holder, a thing that is rare to see nowadays (most power supplies nowadays come with their fuses soldered directly on the printed circuit board).

click to enlarge
Figure 6: Transient filtering stage (part 1).

click to enlarge
Figure 7: Transient filtering stage (part 2).

Now let’s have a more detailed discussion on the components used on MSI Turbostream 600 W.