The middle support can be easily removed by pressing a plastic latch located on the left end; you don’t need to remove any screw. You can swing it to your direction like a door or you can completely remove it but pulling it up.

click to enlarge
Figure 10: Removing the middle support.

In Figure 11 you can have a better look at the 80 mm fan that is attached to this support and also the three plastic mechanisms to hold daughter boards in place. You need to adjust the height of each mechanism until you see that they are really holding each daughter board in place.

click to enlarge
Figure 11: Fan and holding mechanism for daughter boards.

As we briefly mentioned, this case has a removable motherboard tray. This tray comes attached to the right side panel, but you can remove it from the panel, if you want to. We liked this tray as it helps a lot the process of building your PC. Part of the rear panel is also attached to this tray. The slots for installing daughter boards don’t use any kind of screwless mechanism to hold daughter boards, so you will have to use the regular screws here.

click to enlarge
Figure 12: Motherboard tray.

On the right side of the case there is a plastic frame for you to install an additional 80 mm fan that doesn’t come with the product. Note that the right panel has venting holes for this fan. The goal of this fan is to provide extra cooling for devices installed on the three 3 ½” bays located outside the hard disk drive cage. In most configurations you will have only a floppy disk drive installed there – if you still use this kind of Stone Age device.

click to enlarge
Figure 13: 80 mm fan holder on the right side of the case.