The next step is to clear the CMOS memory, which is a small memory located on the motherboard in charge of storing your computer configuration. This is done by changing the position of a jumper or by shorting two pads or two pins on the motherboard with a flat-tip screwdriver. The exact location of this jumper, pads or pins depends on the motherboard, and you must see the exact location in the motherboard manual. (Usually they have “Clear CMOS,” “CCMOS” or “CLRTC” written next to them.) In the pictures below, we give some examples.

click to enlarge
Figure 1: Clear CMOS jumper (you will need to change its position)

click to enlarge
Figure 2: Clear CMOS pins (you will need to short them with a flat-tip screwdriver)

click to enlarge
Figure 3: Clear CMOS pads (you will need to short them with a flat-tip screwdriver)

The procedure is always the same. With the computer turned off (i.e., with the computer power cord removed from the wall), move the position of the jumper, or short the two pads or two pins with the screwdriver and hold it for two seconds, then move the jumper back to its default position and turn on the computer again.

If this step didn’t solve the issue – i.e., if your computer is still not turning on – then go to the next step. If clearing the CMOS memory solved your issue, you will need to do two things. First, you will need to put all the parts from your computer back in place. Second, you will need to enter the motherboard setup and reconfigure it. Your computer will be complaining that the CMOS memory was erased, so you will need to press F1 to enter setup and reconfigure it.