Installing optical and floppy disk drives to this case is a very easy process as well. First you nee to remove the cover from the bay where you want to install your drive. To do that you need to press the lateral of the cover with a flat tip screwdriver, as shown in Figure 25. Then just pull the cover.

click to enlarge
Figure 25: Removing the bay cover.

With the bay opened slide in the drive you want to install until you hear a click, as shown in Figure 26.

click to enlarge
Figure 26: Installing an optical drive.

Even though the bays have a plastic latch (see on the left hand side of Figure 26) which makes each drive to be perfectly in place the drives are still a little bit lose, so you need to screw four regular thin thread screws to each drive.

click to enlarge
Figure 27: Screwing the optical drive.