As we already mentioned you can install up to two additional 120 mm fans on the top of the case (Figure 14) and one additional 120 mm fan on the bottom of the case (Figure 15). As you could see on page two there is a washable dust filter in front of this bottom spot. This case comes with a front 120 mm fan attached to the hard disk drive cage and we will show this fan later.

click to enlarge
Figure 14: Top 120 mm fan and place for installing two additional 120 mm fans.

click to enlarge
Figure 15: Place for installing a bottom 120 mm fan.

As already explained on this case the power supply is installed on the bottom of the case and there is a washable dust filter below the power supply installation spot. Because of the unusual position for the power supply, this case comes with an extender cable for the EPS12V connector, in the case the EPS12V cable from your power supply shows to be too short.

click to enlarge
Figure 16: Power supply installation spot and its dust filter.

One good thing about this case is that it uses thumbscrews to fasten the daughter boards to the case.

click to enlarge
Figure 17: Daughter boards are fastened to the case using thumbscrews.