This step is necessary only if your case has a removable floppy disk drive cage (Figure 8). If this isn’t your case (which is more likely) skip to the next step.

The first thing to do is to remove the front plastic cover by unscrewing it from the cage. In our case we will use the lower 3 ½” bay, so we removed the lower cover.

click to enlarge
Figure 10: Remove the front cover.

click to enlarge
Figure 11: Cage with the front cover removed.

Next put the floppy disk drive in the cage (see Figure 12) and then screw it using all four screws, two at each side (see Figure 13).

click to enlarge
Figure 12: Putting the floppy disk drive in the cage.

click to enlarge
Figure 13: Screwing the floppy disk drive to the cage.

click to enlarge
Figure 14: Floppy disk drive correctly installed on the cage.