Building 26 has less floors but it is not small at all. There are three floors dedicated to motherboard manufacturing (motherboards targeted to notebooks and desknotes) with 14 SMD lines on each floor (for a total of 42 SMD lines) and eight manual insertion lines on each floor (for a total of 24 manual insertion lines). Other two floors of this building are dedicated to notebooks, desknotes and systems manufacturing. On these floors there are three straight lines for notebook manufacturing, six cell lines for notebooks and mini-PCs manufacturing and three lines for systems manufacturing.

click to enlarge
Figure 16: Overview of two notebook manufacturing lines.

click to enlarge
Figure 17: Detail of one notebook manufacturing lines.

click to enlarge
Figure 18: Notebook hard drive cloning.

All ECS notebooks run a 24-hour burn-in test, as you can see in Figure 19.

click to enlarge
Figure 19: Notebook burn-in area.