[nextpage title=”Introduction”]
We are testing today the Arctic Cooling Freezer XTREME Rev. 2, a CPU cooler with two tower heatsinks, four heatpipes and a 120 mm fan. Check it out!
As well as most products from Arctic Cooling, the Freezer XTREME Rev. 2 comes in a plastic blister wrap rather than a cardboard box.
Figure 2 shows what comes with the cooler: just a manual and installation hardware.
Figure 3 displays the Freezer XTREME. The fan comes in between the heatsinks.
Figure 3: The Freezer XTREME Rev. 2
This cooler is discussed in detail in the following pages.
[nextpage title=”The Arctic Cooling Freezer XTREME Rev. 2″]
Figure 4 reveals the cooler from the front, where you see the heatpipes through the heatsink. The four heatpipes are connected to both heatsinks.
The side of the cooler shows a big plastic “X” shaped panel.
Figure 6 shows the rear of the cooler.
Figure 7 presents the top of the cooler.
[nextpage title=”The Arctic Cooling Freezer XTREME Rev. 2 (Cont’d)”]In Figure 8, you see the base of the cooler, made of copper. You can also observe the four heatpipes. The thermal compound comes preapplied on the base surface.
Figure 9 reveals the 120 mm fan, which is easily removed from the heatsink. It uses a four-pin connector, thus supporting PWM speed control.
Figure 10 presents the heatsink without the fan, and here you can see the shape of the fins.
[nextpage title=”Installation”]
Figure 11 shows the clips used to install the XTREME Rev. 2 on AMD systems. In Figure 12, you see the frame that holds the cooler over Intel CPUs.
Figure 11: Clips for AMD processors
Figure 12: Frame for Intel processors
Figure 13 illustrates the frame installed on our motherboard. After this step, all you need to do is put the cooler in place and attach two screws that secure it.
Figure 13: Holding system installed
Figure 14 reveals the Freezer XTREME Rev. 2 heatsink installed on our computer. Now you can reinsert the fan.
In Figure 15, you can see the cooler installed into our case.
Figure 15: Installed in our system
[nextpage title=”How We Tested”]
We tested the cooler with a Core i7-860 CPU (quad-core, 2.8 GHz), which is a socket LGA1156 processor with a 95 W TDP (Thermal Design Power). In order to get higher thermal dissipation, we overclocked it to 3.3 GHz (150 MHz base clock and 22x multiplier), keeping the standard core voltage (Vcore), which was the maximum stable overclock we could make with the stock cooler. Keep in mind that we could have raised the CPU clock more, but to include the stock cooler in our comparison, we needed to use this moderate overclock.
We measured noise and temperature with the CPU idle and under full load. In order to get 100% CPU usage in all threads, we ran Prime 95 25.11 with the "In-place Large FFTs" option. (In this version, the s
oftware uses all available threads.)
We compared the tested cooler to the Intel stock cooler with a copper base (included with the CPU), as well as with other coolers. Note that in the past, we tested coolers with a socket LGA775 CPU, and we retested some "old" coolers with this new methodology. This means you can find different values in older reviews than the values you will read in the next page. Every cooler was tested with the thermal compound that accompanies it.
Room temperature measurements were taken with a digital thermometer. The core temperature was read with the SpeedFan program (available from the CPU thermal sensors), using an arithmetic average of the core temperature readings. During the tests, the left panel of the case was open.
The sound pressure level (SPL) was measured with a digital noise meter, with its sensor placed 4" (10 cm) from the fan. We turned off the case and video board cooler fans so they wouldn’t interfere with the results. This measurement is only for comparison purposes, because a precise SPL measurement needs to be made inside an acoustically insulated room with no other noise sources, which isn’t the case here.
Hardware Configuration
- Processor: Core i7-860
- Motherboard: Gigabyte P55A-UD6
- Memory: 2 GB Markvision (DDR3-1333/PC3-10700 with 9-9-9-22 timings), configured at 1,200 MHz
- Hard disk: Seagate Barracuda XT 2 TB
- Video card: Zotac GeForce GTS 250
- Video resolution: 1680×1050
- Video monitor: Samsung Syncmaster 2232BW Plus
- Power supply: Seventeam ST-550P-AM
- Case: 3RSystem L-1100 T.REX Cool
Operating System Configuration
- Windows 7 Home Premium 64 bit
Software Used
Error Margin
We adopted a 2 °C error margin, meaning temperature differences below 2 °C are considered irrelevant.
[nextpage title=”Our Tests”]
The table below presents the results of our measurements. We repeated the same test on all coolers listed below. Each measurement was taken with the CPU at idle and at full load. In the models with a fan supporting PWM, the motherboard controlled the fan speed according to core load and temperature. On coolers with an integrated fan controller, the fan was set at the minimum speed on the idle test and at full speed on the full load test.
Idle Processor |
Processor at Full Load |
||||||
Cooler | Room Temp. | Noise | Speed | Core Temp. | Noise | Speed | Core Temp. |
Intel stock (socket LGA1156) | 14 °C | 44 dBA | 1700 rpm | 46 °C | 54 dBA | 2500 rpm | 90 °C |
Cooler Master Hyper TX3 G1 | 14 °C | 47 dBA | 2050 rpm | 33 °C | 56 dBA | 2900 rpm | 62 °C |
Zalman CNPS10X Extreme | 14 °C | 45 dBA | 1400 rpm | 27 °C | 53 dBA | 1950 rpm | 51 °C |
Thermaltake Silent 1156 | 14 °C | 44 dBA | 1200 rpm | 38 °C | 49 dBA | 1750 rpm | 69 °C |
Noctua NH-D14 | 14 °C | 49 dBA | 1250 rpm | 27 °C | 49 dBA | 1250 rpm | 53 °C |
Zalman CNPS10X Performa | 14 °C | 46 dBA | 1500 rpm | 28 °C | 52 dBA | 1950 rpm | 54 °C |
Prolimatech Megahalems | 14 °C | 40 dBA | 750 rpm | 27 °C | 60 dBA | 2550 rpm | 50 °C |
Thermaltake Frio | 14 °C | 46 dBA | 1450 rpm | 27 °C | 60 dBA | 2500 rpm | 50 °C |
Prolimatech Samuel 17 | 14 °C | 40 dBA | 750 rpm | 40 °C | 60 dBA | 2550 rpm | 63 °C |
Zalman CNPS8000A | 18 °C | 43 dBA | 1400 rpm | 39 °C | 54 dBA | 2500 rpm | 70 °C |
Spire TherMax Eclipse II | 14 °C | 55 dBA | 2200 rpm | 28 °C | 55 dBA | 2200 rpm | 53 °C |
Scythe Ninja3 | 17 °C | 39 dBA | 700 rpm | 32 °C | 55 dBA | 1800 rpm | 57 °C |
Corsair A50 | 18 °C | 52 dBA | 1900 rpm | 33 °C | 52 dBA | 1900 rpm | 60 °C |
Thermaltake Jing | 18 °C | 44 dBA | 850 rpm | 34 °C | 49 dBA | 1300 rpm | 60 °C |
GlacialTech Alaska | 18 °C | 43 dBA | 1150 rpm | 36 °C | 51 dBA | 1600 rpm | 60 °C |
Deepcool Gamer Storm | 18 °C | 43 dBA | 1100 rpm | 35 °C | 48 dBA | 1600 rpm | 62 °C |
Corsair A70 | 26 °C | 56 dBA | 1900 rpm | 40 °C | 56 dBA | 1900 rpm | 65 °C |
Deepcool Ice Blade Pro | 23 °C | 45 dBA | 1200 rpm | 38 °C | 52 dBA | 1500 rpm | 64 °C |
AC Freezer 7 Pro Rev. 2 | 23 °C | 47 dBA | 1750 rpm | 44 °C | 51 dBA | 2100 rpm | 77 °C |
Corsair H70 | 27 °C | 60 dBA | 1900 rpm | 37 °C | 60 dBA | 1900 rpm | 61 °C |
Zalman CNPS9900 Max | 27 °C | 55 dBA | 1600 rpm | 38 °C | 58 dBA | 1750 rpm | 63 °C |
Arctic Cooling Freezer 11 LP | 25 °C | 45 dBA | 1700 rpm | 51 °C | 49 dBA | 1950 rpm | 91 °C |
CoolIT Vantage | 26 °C | 60 dBA | 2500 rpm | 37 °C | 60 dBA | 2500 rpm | 62 °C |
Deepcool Ice Matrix 600 | 25 °C | 46 dBA | 1100 rpm | 41 °C | 53 dBA | 1300 rpm | 69 °C |
Titan Hati | 26 °C | 46 dBA | 1500 rpm | 40 °C | 57 dBA | 2450 rpm | 68 °C |
Arctic Cooling Freezer 13 | 27 °C | 49 dBA | 1950 rpm | 41 °C | 53 dBA | 2300 rpm | 70 °C |
Noctua NH-C14 | 26 °C | 52 dBA | 1300 rpm | 37 °C | 52 dBA | 1300 rpm | 61 °C |
Intel XTS100H | 26 °C | 49 dBA | 1200 rpm | 42 °C | 64 dBA | 2600 rpm | 68 °C |
Zalman CNPS5X SZ | 23 °C | 52 dBA | 2250 rpm | 38 °C | 57 dBA | 2950 rpm | 69 °C |
Thermaltake SlimX3 | 21 °C | 50 dBA | 2700 rpm | 46 °C | 50 dBA | 2750 rpm | 99 °C |
Cooler Master Hyper 101 | 21 °C | 50 dBA | 2600 rpm | 38 °C | 57 dBA | 3300 rpm | 71 °C |
Antec Kühler H2O 620 | 19 °C | 52 dBA | 1400 rpm | 34 °C | 55 dBA | 1400 rpm | 58 °C |
Arctic Cooling Freezer 13 Pro | 20 °C | 46 dBA | 1100 rpm | 36 °C | 49 dBA | 1300 rpm | 62 °C |
GlacialTech Siberia | 22 °C | 49 dBA | 1400 rpm | 34 °C | 49 dBA | 1400 rpm | 61 °C |
Evercool Transformer 3 | 18 °C | 46 dBA | 1800 rpm | 33 °C | 51 dBA | 2250 rpm | 65 °C |
Zalman CNPS11X Extreme | 20 °C | 51 dBA | 1850 rpm | 34 °C | 56 dBA | 2050 rpm | 61 °C |
Thermaltake Frio OCK | 15 °C | 44 dBA | 1000 rpm | 27 °C | 64 dBA | 2200 rpm | 51 °C |
Prolimatech Genesis | 18 °C | 49 dBA | 1050 rpm | 30 °C | 49 dBA | 1050 rpm | 54 °C |
Arctic Cooling Freezer XTREME Rev. 2 | 15 °C | 41 dBA | 1050 rpm | 32 °C | 44 dBA | 1400 rpm | 60 °C |
In the graph below, at full load you can see how many degrees Celsius hotter the CPU core is than the air outside the case. The lower this difference, the better is the performance of the cooler.
[nextpage title=”Main Specifications”]
The main specifications for the Arctic Cooling Freezer XTREME Rev. 2 CPU cooler include:
- Application: Sockets 775, 1155, 1156, 1366, AM3, AM2+, AM2, 939, and 754 processors
- Dimensions: 6.7 x 4.4 x 6.1 inches (170 x 113 x 155 mm) (W x L x H)
- Fins: Aluminum
- Base: Copper
- Heat-pipes: Four copper heatpipes
- Fan: 120 mm
- Nominal fan speed: 1500 rpm
- Fan air flow: 35.7 cfm
- Maximum power consumption: 1.8 W
- Nominal noise level: Not informed
- Weight: 1.7 lbs (790 g)
- More information: https://www.arctic.ac
- Average price in the US*: USD 47.50
* Researched at Amazon.com on the day we published this review.[nextpage title=”Conclusions”]
You can say the Freezer XTREME Rev. 2 is a weak cooler for its size and design, because most coolers with twin heatsinks and a 120 mm fan perform better than it. On the other hand, its cooling performance is good, and it is simply the quietest cooler we tested so far.
Its bigger problem is the fact that you cannot change its fan for a stronger one, because the fan uses a proprietary shape that allows you to easily install and remove it. If you could install one (or two) higher-cfm fan(s) on the XTREME, you could probably get a much higher cooling performance.
The Arctic Cooling Freezer XTREME Rev. 2 is a good cooler, with good performance and a terrific low noise level. If you are looking for extreme silence on a cooler, this is a good choice.
Leave a Reply